Bead: a font made for 3D printing
https://printago.io/bead

Every stroke in Bead is two extrusion lines wide. That only holds at the right
text size, so Bead comes in three sizes and you set the height from the table.

WHICH FILE

  Bead Small / Medium / Large                 raised text
  Bead Small Cut / Medium Cut / Large Cut     text cut into a surface
  Bead Small Open / Medium Open / Large Open  cut-in text printed face down on the bed

Small is the smallest text that still prints as two lines. Medium and Large are
taller letters with the same stroke.

WHAT SIZE TO SET

Letter height is the height of a capital. Font size is what Bambu Studio,
OrcaSlicer and Printago Studio ask for. Both are in mm.

  Nozzle  Line width   Small            Medium           Large
                       letter / font    letter / font    letter / font
  0.2 mm    0.22        2.9 / 4.2        3.8 / 5.4        5.2 / 7.5  
  0.4 mm    0.42        5.6 / 8.0        7.2 / 10.2      10.0 / 14.2 
  0.6 mm    0.62        8.2 / 11.8      10.6 / 15.1      14.7 / 21.0 
  0.8 mm    0.82       10.9 / 15.5      14.0 / 20.0      19.4 / 27.8 

Line width is the stock Bambu Lab value for each nozzle. For another line width:
stroke = 1.9 x line width, letter height = 7, 9 or 12.5 strokes, font size =
letter height / 0.7. Layer height barely matters.

At twice these sizes the stroke is four lines wide, which also slices cleanly.

LICENSE

SIL Open Font License 1.1. See OFL.txt.
